Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking to confirm if there is a way I can filter the routes I send out on neighbor by neighbor basis. My question comes from the fact I am running EIGRP, have multiple neighbors on a single interface (Tunnel interface on hub for DMVPN) and not ...
Is there any example of a hierarchical DMVPN setup out there?
I have a couple of questions that might be answered by that based on the diagram:
1) What are the advantages of regional hubs vs a consolidated hub and leaving the rest to dynamic tunn...
I have purchased several AIR-LAP1242AG-E-K9 but had no POE switches so I needed power injectors; we ended up purchasing AIR-PWRINJ-FIB without noticing that they were also media converters. Is there any converter I can use to convert back to copper...
I had to lab it myself, as there are a lot of unanswered questions. The link given by vikasgupta2k is useful:
https://www.cisco.com/c/en/us/support/docs/security/dynamic-multipoint-vpn-dmvpn/211292-Configure-Phase-3-Hierarchical-DMVPN-wit.html
I did ...
The neighbors are dynamic, I am looking more of a filter per neighbor, meaning some way of sending a set of routes to a neighbor and a different set to another.
Worldwide I am thinking in the neighborhood of 150 spokes. Most of Asia spoke traffic is to the Asia regional hub (about 50%) to the US East about 30% and the rest to the spokes.
East coast is the main DC on Americas and Europe. West coast is the DR ...
You can define a third interface and do not crete an access list to allow full access to the outside. Here is a small example of how to enable a DMZ interface on a FastEthernet0/2.interface FastEthernet0/2no shutdownnameif DMZsecurity 50ip address x....
