Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a router with two links. One is BGP link and another is Static Route. I want to configure both ink as failover, where static route will be primary and if static route failed it should shift to BGP link. Once static route up again it shoud
We have integrated ISR4300 as H323 gateway with existing CUCM version 8.On Gateway we have two PRI E1 installed and dial plan configured. The issue is when we call from Cisco phone to PSTN network our call got disconnected after four ring and we are ...
Using ASA5506-X
Kindly give suggestion possibility and license which will cover following.
SQL injection prevention. (IP block)
FTP access control / block on 3-5 wrong attempt
Ransomware like attacks prevention.
Log analysis ...report ... Preven...
Hi,
I have a question regards the Cisco SPA8000 Voice Gateway.
Does this support Intercom calling features. Internal Calling on their FXS port.
Regards,
Prem V.
Thanks for the information.
I'll implement the configuration and update you on the same.
Just want to confirm,
Do I need additional port in Router.
OR
The configuration you shared will be work on the existing port.
Regards,
Prem.
Here are My Router Configuration ....
CISCO1921#sh run
Building configuration...
Current configuration : 1950 bytes
!
! Last configuration change at 11:18:44 UTC Mon May 29 2017 by cisco
!
version 15.4
service timestamps debug datetime msec
serv...
