Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Cisco community member.
I have configured the AIR-RM1252G-E-K9 access point (IOS 12.4(10b)JDA3)
Even thought the Interfaces are up I still do not see any service on the wireless media (no SSID or any kind of service on the 2.4 Ghz)
Any he...
Static Route to Null0 interface is not appearing in ip routing table by default on 2921
I have tried same config on 1721 and 892 and it shows there.
on 892
R13#sh run | s ip routeip route 0.0.0.0 0.0.0.0 30.0.0.254ip route 192.168.0.0 255.255.0.0 N...
Hello,
I am setting up MPLS LAB with 3xP routers and 3xPE. When I am sending the traffic from one P router to Lopback interface of the PE router P router is tagging a wrong label. (OSPF is used as internal IGP)
See the picture.
Configuration follo...
Thanks for response Rasika,
I did remove the
channel width 40-below
but no luck - still the same. No SSID or any service on 2.4GHz
Kind regards,
Robert
Thanks for reply,
Some of the information is attached to the post.
Adding all below requested here too:
1) sh ip int brief
Interface IP-Address OK? Method Status ProtocolBVI1 192.168.128.253 YES NVRAM up upDot11Radio0 unassigned YES NVRAM up ...
