About kechengpc

kechengpc · 08-04-2010

A CAT3560G connected with CAT2960S, where can I find example configurations to config VLANs, OSPF or RIP, trunks ,qos, etc. between the two switchs.

kechengpc · 08-03-2010

I am planning a CAT3560G connected with CAT2960S, where can I find example configurations to config VLANs, OSPF or RIP, trunks ,qos, etc. between the two switchs.

kechengpc · 04-21-2010

I plan to deploy GTTD only within WS-C2960S switch, and uplink to layer 3 switch WS-C3560-24TS-S, how can I connection these two?

kechengpc · 12-02-2009

Compared with CISCO2811-CCME/K9, how about C2901-CME-SRST/K9 's performance on voice?

kechengpc · 11-12-2009

What's cosideration for VFR(Virtual route forwarding) under the CME network design?Can we use this to run CME and CCM on the same router?

kechengpc · 01-21-2010

With TAPI function, what's license required? How can caculate the ip phone numbers if have TAPI function?

kechengpc · 01-21-2010

What's function for TSP? How can enable this function on CME?

kechengpc · 01-19-2010

What's teleworker phones? How calculate the phone numbers?

kechengpc · 12-24-2009

Thanks again. Throught the CVO solution, need routers(871,881 or 891/892) on the remote location, another router(for example, ISR G2 2901) on the head end. Any software need? Have a configuration example ?

kechengpc · 12-23-2009

Thanks Jonathan. 7940 ,7941, or 7942 has own DSP to process voice codec, your referring to CPU? With CIPC on netbook(intel atom 240 1.6Ghz,1GB RAM), any experience about voice performance?

Member Since	‎04-07-2008 05:26 PM
Date Last Visited	‎10-09-2017 12:15 PM
Posts	51
Total Helpful Votes Received	5

User Statistics

User Activity

CAT3560G connected with CAT2960S

CAT3560G connected with CAT2960S

2960-S switch uplink

2900 ISR G2 CME support

CME with VRF

Re: CallManager Express TAPI TSP Windows 7 64bit

Re: CallManager Express TAPI TSP Windows 7 64bit

Re: UC540 Phone Licensing

Re: 7940 phone registration over WAN pub IP

Re: 7940 phone registration over WAN pub IP