H Frye,Can you please post more information preferably in a diagram as to where these networks 192.168.132.0/24 are placed and how are they getting introduced into EIGRP and BGP?Best Regards,Naveen

The log says that the access-list is not matching for the VPN tunnel. Not sure how it works after a restart though. Will be helpful if you post the complete config. On the Checkpoint and Cisco VPN, please ensure that you set the phase 2 SA lifetime a...

The requirements mentioned are not clear. I am assuming quite a few things here ;). you can ask one isp to provide an ethernet link and connect one link per router. and then connect both these router to the ASA and then use the L3 and L2 switches in ...

1. SUP 720 will need to be palce in either slot5/6. So you need to consider cabling if the currnet slot 5/6 is occupied.2. Take backup and verify the config as some commands might not have been applied.3. Check if the existing power supplies and fan ...

192.168.0.0 255.255.0.0 should work. IF it is not working, check your logs. It might not necessarily be getting blocked by the access-list, it might also not be working due to spoofing, routing, NAT or other issues.