Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
did you check this document:http://www.cisco.com/warp/public/110/pix_pptp.htmltake a look at the example. That should work for 7.0 as well---------------Commands to Add to All Versions In this configuration example, the PPTP server is 209.165.201.5 (...
Are those two routers on the same internal subnet? If so, you can setup HSRP between them and point pix default route to a virtual HSRP address. This way you will have some redundancy (when one router dies, another one become active) and also once yo...
It would be easier to answer your question if you mentioned what are you trying to achieve... Anyway, if you have DHCP server on your PIX-501 you don't even have to configure any IP for PcB -- when PcB arrives it will get the next available IP from y...
Yes, there are some tools available on the Internethttp://www.handhelds.org/z/wiki/md5sumThe MD5 sum for pix633.bin is bbb8d71e956ac689c39e59bc8fe11766
