Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After a helpful rollback to 18.107.10 from support, our MX95 is now properly handling IPv6 traffic on its WAN port. The problem is, that any IPv6 traffic that is initiated on the test VLAN I have set up right now is not making it out of the WAN port...
I'm getting ready to finally roll out dual-stack IPv4 & IPv6 at work. I would like to use our domain controllers for DNS as I do with IPv4, however, for the VLANs I do not use our MX95 as the DHCP server for (most of them) there is no way to specify ...
I am starting the process of deploying an anynode SBC for our transition to Teams Voice. I have the SIP trunk configured on the anynode, and the Teams portion working great. However, only outbound calls from our CUCM through the anynode work, incom...
I am trying to enable SAML SSO on one of our lab servers and no matter what I do I cannot get the "Enable SAML SSO" button to work. I am logged in as an administrator, and I have tried multiple administrator accounts, but none of them work.
Versio...
Last night my PC rebooted for Windows updates and now I am getting error 789 trying to connect as is one developer (his did the same thing). Worked great before the update. We do have access to the AnyConnect beta, but then we lose complete access ...
I'm capturing the packets on the dashboard. I can see the ICMP6 echo request leave the MX95, then nothing coming back.The MX95 gets its connection via a direct single-mode fiber from Lumen in a data center (so business use, hence the single test VLA...
The bigger issue I'm having right now is that we are finally in the data center, and I have IPv6 configured on the WAN. But from the dashboard, I cannot reach any IPv6 address from our MX95. Lumen says all is good on our end (of course) and Meraki ...
