Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
An additional tip for troubleshooting authentication from the UCS side would be to utilize the 'debug aaa all' command.
1) SSH to the virtual IP for UCSM.
2) Run 'connect nxos'
3) Run 'debug aaa all'
4) Run an authentication attempt to UCSM with th...
Re-initializing or re-building that RAID is going to blow away any data stored there, so there is not a way to simply re-apply a previous RAID config unfortunately. I personally have never heard of drives falling out of RAID for any reason, certainl...
Your questions is also dependent on the firmware installed on the server, the CPU model, as well as whether it is integrated into UCSM or running in standalone. The best answer to your question here that I can give is the following link:
https://u...
Port groups are a part of virtual networking at the ESXi level. I am unsure as to what you mean when you ask whether you need to integrate ESX with UCS. Please define what you mean there, I think that would be a reasonable place to start.
As for ...
I don't see an attachment here, I would also not recommend uploading any logging or attaching output to this forum as it is public and could pose a significant security risk.
As for your current problem I would recommend opening a TAC case if you h...
