Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking for assistance with our PRIs connected to Cisco ISR 4431, Cisco IOS XE Software, Version 16.04.01.We are connecting via PRI to local vendor for local/incoming and outgoing (2 way) service.Calls are working correctly but every so often (which ...
I have a server that is not responding when trying to access through GUI interface. We can ping the address and also access CLI from SSH session. I saw there was a bug found but I believe our version (3.0 (1c)) is passed the bug fix action. We did po...
We have had an issue with "call masking" numbers. It works, however, it will still show the "real" number in ( ) below the mask on internal calls. If I remove the partition for phones internally and force the call out of the Call Manager and back in,...
We are expexriencing similar issues. Were you able to find a solution or did any of the replies help you fix the issues?Seems like it "times out" and returns to normal service after a while. I suspect we are having an issue with the carrier.Not sure ...
Thanks, that is a good point. I thought that as well but some of the PRIs are connected to a different switch all together and they are also having calls when initiating calls. Strange issue because the same circuit will pass traffic and then fail th...
Evan, thank you for your time. I did "reboot" the CIMC service from the CLI and it DID work! We are now able to log into the CIMC via the GUI like we had in the past. What I noticed is when the server went down after a power issue, it said "ac-cycle"...
We want to use a number that has nothing to do with the correct number. For example, the extension may be 3300. when this caller dials me at 3322, I want it to be masked as 320-4000. The 320-4000 is the "mask" I want associated to make callers think ...
