We have an ACE 4710 that has two web servers in an active/passive scenario. The issue is that if node 1 fails and node 2 takes over connections to node 2 stay active even if node 1 becomes available again. Is there are way to ensure that node one i...
Currently we have a Cisco ACE 4710 doing a lookup for an image on a website to determine whether the site is available or not. Is there any way to get the ACE to query the server (probably using SNMP) and failover if the server's processor stays abo...
Probe Interval: 5Pass Detect (Seconds): 60 Fail Detect: 3Please can someone explain the above settings that are configured for a health probe? am I correct in thinking the probe is sent every 5 seconds, and must fail 3 times in order to failover? D...
We have two internet connections, one for voice and one for data, we are using IPSLA to provide failover between the two, however if the voice link fails we always have to run "clear xlate" to get the phones to come back online
Am I correct in thinking that Active/Active failover is only applicable if you want to utilize 2 hardware appliances (ASA) to act as the respsective active/standby for two or more security contexts.. and you cant have 1 security context active on eac...
In the whitepaper I read it said it should look likenat (inside,outside) source static obj-192.168.1.0 obj-192.168.25.0 destination static obj-192.168.100.0 obj-192.168.1.0but I wondered if the end was a typo?also I seem some packets pass but all of ...
