Hi,I have following design question: If i have two NSSA ABR's and both are injecting a default route to the NSSA area, which route will win? Is the election of the default route inside the NSSA are based on costs too?Thanks,Robert
Hi,Is there any document available where I can see when the BFD feature is supported in the 7500er IOS? In the 12.0(31)S there are some cli commands already implemented, but the feature itself does not work at all.Any ideas where I can get more infor...
Mujeeb,I order to achieve multiple BGP paths to the same destination in the routing table you have to meet following criteria's:- equal weight, local preference ... and more.Please have look on following Cisco document:http://www.cisco.com/en/US/part...
Hi Martin, Thanks for you reply. I had a discussion with one of my colleagues who mentioned that a router inside NSSA perform allways load sharing, even if the costs of the default routes are different and i wasn't so sure anymore who is right :-)Bes...
Nat,Thanks for the link. I already know this document. According to the feature navigator only the 12xxx series and the 7600 is supported at the moment. I was just curios, because some of the commands are in the CLI Interface from the 7500 IOS. I cou...
