Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Day,I'm doing the initial (and test) configuration of a cat 3650. I can't seem to get the routes to default out to the next hop router. Inter vlan routing succeeds and I can access hosts beyond the next hop router from the router itself. I'm hop...
Good Day,Our network serves a residence hall on a university campus. At present we have 7 100mbps links (and 7 subnets), to the router on campus to serve, on average 350 concurrent users. For budgetary reasons we are considering going with a private ...
Good Day,We have an ASA 5550 v8 installed to provide nothing more than one to one dynamic nat in a large college residence hall. (One public IP is reserved for PAT in the event that the public one to one pool is depleted).As a college residence facil...
Good Day,I have seven subnets that previously used public IPs exclusively w/helper addresses configured on a router that I *do not* control.We recently installed an ASA 5550 to do nothing more than perform NAT for five on the subnets, the other two r...
Thanks for the answer, but it seems some clarification is necessary. I have four outside ports (out1-out4) and four inside ports (in1-in4).The outside ports are configured with public IP addresses on the same subnet as the router port to which they ...
To clarify:In the web management interface of a 2106 if you go to Security=>AAA=>User Login PoliciesThere is a setting for maximum number of concurrent user sessions. The default is 8, which is the limit.I thought this would apply only to local user ...
According to the configuration guide, as long as the speed and duplex are set for auto, mdi/mdx will be auto as well. That said, I have tried both crossover and straight through on both inside and out and both remain down.
