I had a CM7 running in VMWare 4.0, but I upgraded my POD to 4.1, and I got UC8 just today. It gives me an error complaining about base_scripts/hardware_check.sh Input Output errors. The errors happen almost immediately. I have set it up on Intel...
I am not sure if I have a bug or if it is supposed to be this way. I have dual isp support working properly but the customer now wants to be able to route certain ip blocks out the "backup" interface. i add the static route and it takes it in the rou...
We had a backup ASA 5510 die. When consoled in I saw that it could not find an image. I did a tftpdnld and got it up. Now the issue is that it does not recognize its flash or disk 0. When I do a fsck it says unrecognized format, and if I try to do a ...
We are running version 4. Your suggestions almost got me fixed...the issue is that this operator phone needs to have the ability to forward to two different call handlers. One for after-hours(1140) and one for walked-away(1141). I set up routing rule...
I had almost the same scenario, except for new hardware. I had the upgrade fail multiple times using DiRT, and TAC did not offer an explanation. I had to restore to the original version at the end of each attempt. In the end COBRAS saved the day.
So just to clarify:dial-peer voice 50 pots description Germany destination-pattern 901149..........T port 0/3/0:23 prefix 011However, forward-digits 0 gets inserted.