About Jelani_DTE_PRO

Jelani_DTE_PRO · 10-18-2020

Hello. So, I have this little issue... Whenever, a recently purchased Hikvision NVR LAN port is configured with IP settings specific to a VLAN created on my WS-C2960+48TC-L switch and connected to a switchport that is configured as an access port for...

Jelani_DTE_PRO · 03-12-2020

Hello. I am planning to create a stack, between an existing and new 3850. I would like to know, if I have to configure the new switch with (e.g. SSH, SNMP, switchport access, etc), or does SSO makes it possible for the new switch to use the existing ...

Jelani_DTE_PRO · 01-29-2020

Yesterday, I configured a 2960C switch to make part of my lab. Initially, I created a VLAN...an SVI for that VLAN and assigned it an IP Address...assigned an access port to that VLAN...and, configured a default gateway. I connected my laptop to the a...

Jelani_DTE_PRO · 01-07-2020

Okay. So, I have three 2911 lab routers that are configured for remote connectivity using a default route and the next hop address of my XFINITY router. At the same time, I'm trying to complete OSPF labs that redistribute static subnets. Of course, t...

Jelani_DTE_PRO · 12-17-2019

Which command should I use, to learn the device MAC address for a 2911? I'm configuring Port Forwarding, for access to my lab equipment. And, in haste last night, I executed a "show version" on my 2911s, thinking I would find their respective MAC add...

Jelani_DTE_PRO · 10-19-2020

Hi, Paul. Gotcha! In the case of administrative mode, using switchport mode xx, I did. Thanks, for the explanation; haven't heard it like that, in a while. As for port security, it was removed before communication was tested and prior to port securit...

Jelani_DTE_PRO · 10-18-2020

Hi, Paul. Hmmm... Will you give me an example, of an administrative mode type of config on a switchport? Here's how the port, has been configured... Again, I was able to successfully ping the NVR for about 5 minutes from the switch. And, the vendor w...

Jelani_DTE_PRO · 10-18-2020

Hi, Georg. I've actually had to disable port security and MAC sticky, on the switchport. Whenever it's enabled, the Hikvision connection causes an immediate port security violation...causing the port to shutdown. I was pinging, from the switch that t...

Jelani_DTE_PRO · 03-12-2020

Got it. Thanks!

Jelani_DTE_PRO · 03-12-2020

Hi, Leo. Will that take place via SSO or the software auto-upgrade enable command?

Member Since	‎06-16-2008 09:26 AM
Date Last Visited	‎06-09-2021 01:07 AM
Posts	58
Total Helpful Votes Received	10

User Statistics

User Activity

Hikvision NVR (DS-96XX) and WS-C2960+48TC-L

Cisco 3850 start-up config (Stack)

Cat 2960C

Default routes on 2911 lab routers: One, for remote connectivity; and, one for OSPF lab

Device MAC Address for a 2911

Re: Hikvision NVR (DS-96XX) and WS-C2960+48TC-L

Re: Hikvision NVR (DS-96XX) and WS-C2960+48TC-L

Re: Hikvision NVR (DS-96XX) and WS-C2960+48TC-L

Re: Cisco 3850 start-up config (Stack)

Re: Cisco 3850 start-up config (Stack)