Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey community,does anyone know if the MAC-Address is also somewhere displayed outside the packaging?We are mainly receiving MR46, MR46E, MR56 and MR76 and need this information for printing the AP's labels as early as possible (before sites do unpack...
Hey everyone,I am very new to Meraki products and never held one in my hand till now. While I am planning various roll-outs with Meraki hardware I am here to get assistance in checking if the hardware ordering was correct in terms of powering the new...
Use MR56 and yes, definetely predictive site survey to be sure. Too many APs is a waste of money and you can find third parties who will make you site surveys of <1.000€ for such areas. If you save one AP (plus installation) by that, you already made...
I recommend to use MAC-table via switch if you do have access to switch. Something like CDP neighbors can help to find MAC addresses. You can then match these with serials in dashboard. Disconnect from switch ony by one and YES, use binoculars or swi...
During my search I ran over your question. Depending the height, I usually go with MR46E with Antenna type A, B or C,D. We see good results with MR46E+ANT-B6 at heights between 6-9m. Above that you will see blind spots right below the AP. We also cre...
Hey @Marcel Tempelman ,update on that site, referring to your assistance: We changed the design to F6-Antennas (height ~11m) at both ends und using B6-Antennes in between (also ~11m). On a different site, they used F6-Antennas at ~5m at both end of t...