Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm using the ACE to perform SSL offload infront of the servers. That is, clients talk 443, backend servers are 80. Is it possible to rewrite the URL's embedded withing a web page (inside javascript I think too) that is being generated by the server ...
I have a SCE1000 running 3.5.0 (or 3.1.7), and every time it reboots, it goes into recovery mode. When I connect, it prompts for the initial setup questions, and when it tries the save them, most of them fail because it is in recovery mode. Also when...
I'm running LMS 2.6, and the autodiscovery process reports 150 unreachable devices. These devices turn out to be Cisco light weight access points. As LWAP do not run SNMP, but do run CDP, LMS sees them but cannot understand them. I know it is possibl...
Hi,Does anyone know how to remove the requirement that usernames be a minimum of 5 letters for the local usernames database. I cannot link Ciscoworks to using Active Directory under AAA, as my domain username is only 4 letters, and hence I cannot cre...
I am not able to do device discovery anymore. It was working. I am seeing the following across the top of the latest discovery report.Campus Manager Administration Device Discovery-All Devices Report as of 28 Aug 2008, 05:48:14Last Discovery Start...
Try setting the port in question to layer 2 ("switchport"), the internal vlans are created for L3 ports. This will possibly remove the high numbered internal vlans.However, if you read the error it is complaining about vlans in the 1-1005 range. I su...
Hi, just to clarify, the external login module is the module that allows me to interact with AD? So disabling it would disable AAA to AD and revert to local usernames anyway?
Hi Ankur,That fixed the problem. but created a whole lot of questions. With a WiSM, which is actually two controllers, I have the two controllers set up as primary and secondary for each AP. I can only set the power options on the currently associate...
