About fjrubiobarcena

fjrubiobarcena · 10-26-2009

Hello I installed the latest device pack in a callmanager 5.1 cluster. I am having problems with the ip phone getting the new firmware ("tftp auth fail") and I wish to install a device pack older than that; How can I make a downgrade of the device pa...

fjrubiobarcena · 10-09-2007

I have configured some manager each one with one assistant associated I worked fine. Now one the manager's ip phone is not working fine (I am doing a rma request) and I have changed the fault ip phone with a new one (both of then are 7961), I have as...

fjrubiobarcena · 09-21-2007

We had a voice gateway (cisco 2821) with the voice ports backhauled to the callmanager (ccm 5.1), in this gateway we had 2 isdn e1 ports (working OK for voice calls) we have too 3 vic2-2bri cards. The question is: Can we use the bri interfaces to con...

fjrubiobarcena · 09-10-2007

After a reboot I have lost the "bulk administration" option in the ccmadmin web page. How do I get it again?

fjrubiobarcena · 09-02-2007

Hello I am configuring a new gateway with an e1 pri to the pstn. And when I try to make a new call i received the following error:"ZAVGW001#*Aug 31 11:38:19.079: ISDN Se0/0/1:15 Q931: TX -> SETUP pd = 8 callref = 0x0001 Sending Complete Bearer Cap...

fjrubiobarcena · 11-10-2010

Hello, did the reset worked? have you had the issue again?One of my customer have a similar problem, some of the poe interfaces from one of the cards stop working. They had an ip phone receiving poe in one port (for example 1/17) if the try to plug a...

fjrubiobarcena · 10-26-2009

Thanks for your help. When do I change the device defaults, before or after rebooting the ucm once I have installed the older device package?

fjrubiobarcena · 10-06-2009

Hello, I have installed in a callmanager 5.1 the latest device package and I am having the same issue. What do tou think it can be the solution?unninstall the latest device package and install an older one?

fjrubiobarcena · 12-27-2007

Hello, wich tool do you use to make easier when you read the traces? I usually use the notepad or excell but is very hard to follow or to find a call or the registration of a device.

fjrubiobarcena · 10-15-2007

I tried to restart the service the last week(it was the second thing I tried) but it was uselessThanks for your help

Member Since	‎08-30-2006 11:43 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	38

User Statistics

User Activity

How to downgrade a device pack

ipma - weird error

remote connection

no bulk administration (ccm 5.1)

E1 call setup fail

Re: No inline power on a 4506-E port.

Re: How to downgrade a device pack

Re: CUCM 7.1(3) TFTP Auth Fail

Re: Log of last SIP device registration?

Re: ipma - weird error