Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allI have a problem with NAT on ASA. I am trying to translate the destination IP based on source range and source port.I am getting a log below.Failed to locate egress interface for TCP from OAM_MDS_EXT:169.254.0.1/52464 to 8.2.3.1/161 .Range 8.2....
Hi all,I am scratching my head how to isolate the traffic for management and data plane.Scenario is following: - I have local management system which I need to use. It is on the local lan- I have two SSIDs, Corp and GuestQuestion is for do I change t...
Hi all,I am new with Meraki and I have some doubts how to configure two SSIDs in the office. I have one SSID CORP in Bridge mode using DHCP server and I have Guest SSID in NAT mode. I want Guest to not be able to reach Corp network but because NAT mo...
Hi all,
I had a request not so long ago to do QinQ. We bought c3650 but then we realized that we can't do it on one device and we actually need VLAN mapping..
I see that ME3600 has that option.I found out that 4500x also can do that SUP engine needs...
Any idea what we could do in the case when IP sla is not available? e.g multy-context firewall ?How do we make a condition to remove the static route in the event when we lose an uplink for example ?
Hi Zac,thank you for your reply. Maybe I didnt explain my end goal correctly. R1 on the left is using SNMP server 10.10.0.1 on the right. SNMP srv is not presented with the real IP to R1 so R1 uses 8.2.3.1. In order to make this work I am trying to t...
Sorry I didnt explain that fully.Yes I do have AP connected to the L2 switch and yes it will be a trunk. I want to have mgmt vlan and LAN vlan.Mgmt vlan needs different gateway then LAN vlan.Switch will be Meraki and Cisco depending from the size of ...
