Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This is a little breakdown of our network.Inside network points to an IP on a layer 3 switch (10.150.55.1/24) for a default gateway.DMZ network points to an IP on an ASA (172.16.1.1/24) for their default gateway.Layer 3 switch has the ASA (10.150.1.2...
We're running ASA 5510s. We have a web server that we'd like to load balance. Basically if someone tries to go to the site, they'll go to one server or the other. Is this possible to do with the ASA? I read that it might be possible with a NAT pool. ...
We have an ASA 5510 and have it set to enable Threat Detection and "Shun hosts detected by scanning threat". I attached a screenshot of the ASDM. Once a month we send out a video to our member firms and one firm will continually get shunned. It happe...
We have an office in Bermuda and 2 offices in Chicago. The 2 offices in Chicago have the same IP scheme - 10.150.1.0/24. I'd like to set a site-to-site VPN up from Bermuda to each of the Chicago offices. I have one up and it works fine. When I set up...
We have Cisco Aironet 1130AGs. We are going to transition our network to WPA, but now it's all WEP. I'd like to set up WPA Migration mode on all of our access points so WEP and WPA clients can access it, but I'm having problems setting it up. Does an...
Thanks for the response.The management access interface is set to inside.I just can't figure out why I can ping the 172.16.1.1 interface from a server on that network, but I can't from a server on 10.150.1.0 network. It appers that it's accepting pin...
Thanks for the response.I'm trying to do this for a public web server, not internal. Can I somehow use the ASA to send traffic for the public IP to 2 different servers in the DMZ - round robin or however?
