Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,I have a functioning RA VPN to a site. It is all very simple bar one issue. I cannot access the DMZ once I have connected to the RA VPN.I am using an ASA 5505 with 8.3DMZ: 10.2.2.0/24INSIDE: 192.168.2.0/24OUTSIDE: DHCPRA_SSL_ADDRESSES: 192.168.10...
All,I am responsible for a the network infrastructure for a company which provides streaming television to mobile devices. For reasons concerning Radio Networks in telco environments, I am looking to limit the bandwidth available to one particular se...
Hi All,After battling with, and eventually learning from the ASA 8.3 NAT configuration, I have stumbled over another hurdle which is causing me some confusion.I have PAT working quite well for one host. That is, OUTSIDE:2202 ---> INSIDE_HOST:2202. Se...
Hi All,I'm well aware that there must be several posts on this topic already (I've read a few) and even searched other articles, but I am having no joy whatsoever. Perhaps this will be a chance for someone to get 5 easy points.I'm currently running a...
Hi All,I've been reading http://www.cisco.com/en/US/docs/security/asa/asa80/getting_started/asa5505/quick/guide/rem_acc.html and following the steps to create a remote Access VPN. At the end of this post is the config delivered to the FW.I am testing...
Hi Lei Tian,Thanks for the info. Luckily, we do have 6509 with a 720 supervisor. I've read a doc from Cisco on how it works and it might just do the trick. I'm a bit worried about our customers complaining about dropped packets and TCP retranmissions...
Hi Pratik,I'm know next to nothing about IP telephony, but from what I read I wanted to ask if you have configured the switchport security to use sticky addresses? i.e. 'switchport port-security mac-address sticky'This will in conjunction with your m...
Hi Matt,At first glance I can't see anything wrong (I did stay up rather late lastnight so I'm not at my best today). So, I would recommend applying thefollowing configuration under the interfaces that are connected to eachother by the fibreinterface...
Matt,'show running-config' will show the running config. 'show startup-config'will show the config that is saved to nvram.After making changes, be sure to execute 'wr mem' to save the running confto the startup conf.You can also copy the running or s...
