Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 5508 WLC that for whatever reason cant take any DNS settings, but I still need to get some filtering on the public hotspot side of my wireless network. Can I put the DNS settings on the router that the circuit terminates on? This is the same...
I'm trying to set the tcl source to the flash card on an 1861 router with the following command;TestBox(tcl)#source flash:101.tcland I get the following message; couldn't read file "flash:101.tcl": File not foundI've copied the file to the flash card...
I want to have one of my routers send out a ping every 5 minutes or so, what's the best way to automate that? I'm looking at the kron scheduler now and I've at least gotten the kron job created but the scheduling is still not where I want it. What I'...
I have a hub and spoke network with over 100 remote sites that connect to me via ipsec vpn. One of these locations, the only one using FIOS coincidently, is initiating 200+ tunnels back to my side which is causing saturation issues on my DS3.So my qu...
Big buffers, 1536 bytes (total 86, permanent 50, peak 114 @ 4d13h): 86 in free list (5 min, 150 max allowed) 12795878 hits, 285 misses, 819 trims, 855 created 0 failures (0 no memory)I'm just looking for some general input on tuning the b...
I'm mostly just looking for some content filtering, not specific URL's. I have several thin AP's connected to the controller from remote sites so all the hotspots run through the controller. I'll follow this thread up with my solution.
Ok so I think I can accomplish this with tcl and here's what I've got so far. Keep in mind that I need to copy a file to the router via tftp then change the config to reflect the new file.typehead "y" #this should answer yes to the confirmation of a...
it's been a while since I visited this project but it's back on the table; here's where we are.Using kron wont work by itself because it will only perform exec level commands that require no user interaction/confirmation. Copying files to the router...
You are correct sir!It was the script running. The script was trying to remove my default route and replace it with another one. Then go into one of the interfaces to remove the crypto map and place it on another interface. Basicaly just swap my vpn ...
