Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, This may seem ridiculously easy but when I bring up a new WAVE appliance they get assigned to a location that appears to be the name of the device with location at then end. I do not see anywhere in the Locations section to assign devices to a lo...
Hi,
When configuring QOS on the 3750 switch the following message is displayed when looking at the queueing configuration of an interface;
Shaped queue weights (absolute) : 25 0 0 0Shared queue weights : 1 30 35 5The port bandwidth limit : 100 (Ope...
Hi,
We have 50+ remote sites where we run an EEM script that shut's the main tunnel interfaces and forces the site to run on backup once a month. After 24 hours another script executes and brings the main tunnel interfaces back up.
This has been wor...
Hi,
I am running a POC to enable DOT1X on our switches. We are using certificates on the laptops and a Cisco ACS server running 5.8.1.
We get to the point where the ACS server sends an Access-Accept to the switch for the DOT1X request but then the ...
I was able to find where you make the change. It's actually under the device activation screen. All of our activations were done right from the device list and were never prompted to pick a location. By going into the device itself under the activati...
