Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good evening,
I've a problem with the Server CISCO C220 M4.
http://www.cisco.com/c/en/us/products/servers-unified-computing/ucs-c220-m4-rack-server/index.html
The 6 FAN on the motherboard don't work and the temperature is too high. The LED blinking...
Hi,
i have any problem with a C220 M4 Server.
I configured the CISCO 12 G SAS MODULAR RAID CONTROLER with one virtual drive in RAID 5 (boot true).
After in the bios i enabled [HBA] on the OPROM module
But when i launch the installation of WINDOW...
Thanks a lot Manish !! all is ok.
but for information i must configure boot in the bios.
1 - go to option boot in the bios
2 - add new boot
3 - give a name + uefi way to boot
For me the way is :
<..>
<Microsof>
<Boot>
|____Boot64x.uefi
Hi
go to attachment to know the boot.
I tested your procedure : set as boot drive is ok.
But no change.
PCIe = no uploaded in my BIOS BOOT DRIVE.
I do not understand. Normally though I have misconfigured my VD . I must see the SLOT [ HBA ] in BOOT...
Hi,
I do not have a PCI card in the BIOS BOOT. Track start maybe.
And for the article :
http://www.intel.com/content/www/us/en/support/server-products/raid-products/000006981.html
It's ok "controller bios = enable"
I can't upgrading for the moment. The serveur are one of the latest version of firmware.
Can you explain for the boot device I searched but I did not find the option to force CIMC ?
