Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So as subject states I'm trying to replace an old SPA112 with a new ATA191 and I've 'mirrored' my old settings in the new unit and did notice that there are a few more new settings in the ATA. But, having mirrored the settings, the ATA191 won't regis...
Researchers have disclosed a serious weakness in the WPA2 protocol that allows attackers within range of vulnerable device or access point to intercept passwords, e-mails, and other data presumed to be encrypted, and in some cases, to inject ransomwa...
As the subject says; I have a SPA 112 unit which has been pre-configured by an ISP - Is it possible to one way another to retrieve the configuration from this unit? I can initially log into the unit if i perform av factory reset; but after 30-60 seco...
Recently installed a SPA112 which so far works fine with exception for some minor issues which I hope to solve. Among other I've noticed that when I place an outgoing call there is a slight delay of 4-5 seconds before I here the ring tone for the cal...
Recently installed a SPA112 unit which so far works fine and without any bigger issues but have a few minor issues to solve. Among other I can't get the anwering machine to record incoming messages; when there is an incomming call which the answering...
Are you saying that it's not possible to utilise the ATA-191 to replace the SPA-112 which is actually what Cisco's EOL documenent recommend as replacement unit? Also, to my understanding the ATA-192 only has an extra network port so not sure what els...
I'm using MPP ATA as I'm using local 3rd party PBX from regional ISP who doesn't support SIP provisioning (well at least not for the ATA-19x). So when using the SPA112 towards the same 3rd party PBX provider I've just configured everything manually a...
Closeing this thread as there is an existing one covering this topic https://supportforums.cisco.com/t5/security-and-network-management/severe-flaw-in-wpa2-protocol-krack-attack/m-p/3199201
With 264 different areas codes including various payment numbers and mobile numbers 7[0237]XXXXXXX serier it's a challange. The closest login is that you can bundle and tie together several of the area codes to a specific region; for example 040 (Mal...
Five star it is! While on the topic when it comes to configure the SPA112; but are you aware if there are any recommendation on how to confugre the SPA112 based on region and what parameters which are wiorth looking into. While I usually live by the ...
