Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hej Community,
I know there is a lot of documentation, configuration/deployment guides, articles and discussion around mDNS and Bonjour usage in wireless infrastructure. For my actual customer requiremens I need a simple clarification on the followin...
Hej community,
for quality assurance and troubleshooting purpose I´m searching for ideas and/or solutions how to verify the valid conenction (or at least some indications) of antenna and accesspoint. In large deployments we noticed that sometimes a l...
Hello Community,can someone please provide a step-by-step guide (or at least the VSA part) for RADIUS configuration on a Windows 2008 R2 server for Prime Infrastructure 2.1 please?We already tried several setups with guides for PI 1.4 without success...
Hello Community,has someone experience on how to add additional AP licenses to a running 5508 1:1 HA installation (running on code 7.5.102.0) ?Do I have to disable HA first, apply the license on the primary, and then again configure HA ? Or is it pos...
Hi community,we have a running Prime Installation (setup a few month ago), and since the last 2-3 weeks my customers admins complain that the system´s response time is very slow, regardless which browser they use. I already did a "ncs cleanup" throu...
Thank you very much for the input. This detailed instruction is great, it points out the configuration differences between NCS and Prime Infrastructure. We had several issues...- in case of CHAP between NPS and Prime you need "store reversed password...
Hey,today I faced the same problem, a fresh MSE 7.5 installation with a really annoying setup script, not allowing me to configure a root password. Did you get an answer or in the meanwhile have a solution ?Thank youRegardsBenjamin
Hello Scott,thank you for the quick answer. I can confirm the behaviour. Interesting, seems that the address ranges in my projects were large enough to cover this scenario. Well, I think the reservation of all IP addresses of the accesspoints seems t...
Just as a follow-up: It works fine. You just have to add a new vlan and tell the switch to it as the redundancy vlan (wism redundancy-vlan x). Don´t forget to add it to the trunk between sup <-> wism. After that just normal HA configuration and it wo...
Okay, I wasn´t aware of the two software partitions of the controllers. This makes it possible to switch back fast and recover the old software/config if needed. In the end it looks like that we need a lab to test the software before updating a contr...
