Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup an MX unit. Here is the way i have it setupInternet 1 is set to SFP. Connection Type is direct and no VLAN tagging. it's set to static IP address that has the Ip address, netmask, gateway that was given to me by the ISP. DNS ...
I am relatively new to this, but i have some questions.I have a ATT Fiber Connection that is SPF+ and LC. Would this type of connector work? It is 10G but i am a bit confused on the duplexing on it. The connector in question:https://meraki.cisco...
I have a quandary. I have 6 MS access points we just setup. 5 of the 6 work just fine. One allows us to connect but it continually says no access. We are not doing PEAP/EAP or any radius configurations. We have pushed a profile via intune to have...
I am new to Cisco Meraki. I need to setup 3 vlans with Different DHCP from my zyxel firewall. This is the error I keep getting. What am i doing wrong? I have the ports on the switches configured for the ports on the zyxel and the various DHCP se...
I read that and I think i understand now better. Here is a question, does it matter which active internet is labeled here? For example Can internet one be ethernet or does it have to be SFP?Thanks,Dan