Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I connect a certain network into a port setup for a specific VLAN on my CAt 3750, I cannot access the DHCP scope that I setup on the router for that subnet. I put in an IP Help-address statement, but DHCP is still not working. Should I be doing ...
I am trying to manage bandwidth of 192.168.1.x to restrict it to 512 kb of Internet access while allowing another subnet full access. Can you recommend the best way to do this?
I have a VLAN setup on a switch that assigns 192.168.6.x to a specific port on my switch. I then have a dhcp scope for that address range in my router config. DHCP works on 192.168.1.x but it does not on 192.168.6.x. I can assign a manual address at ...
I would like to restrict 192.168.1.x in a routed network from only getting 512 MB of Internet access while users on 192.168.6.x have full bandwidth access. Is there an easy way to do it? Both IP addresses are subinterfaces on my LAN side, and the WAN...
I have an Internet router that has a T1 card. Is it possible to limit one set of IP addresses that access the Internet to a certain bandwidth, while giving another set of IPs full access to the bw?
