Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We have 2 ASA-5516X that we will be architecting in a fail-over configuration.
If we have the cert setup on the primary firewall, do we need to setup a cert on the secondary as well?
Trying to verify how the Smart Connect client needs to be set...
Hi,
I have 3 3750's in a stack configuration. I need to reset to factory default in order for me to give them to another company to re-use (probably same stack configuration).
What is the best way to factor reset these? I wasn't sure what happens i...
Hi,
Have 3 switches in a stack, I know the passwords just prepping to hand over to other company
Just looking to verify this is what is needed:
Log on to primary switch
Switch# write eraseSwitch# delete flash:vlan.datSwitch# reload
Can I also do this...
Hi,
I have 2 ASA 5510's (Pri and Sec). I know all the passwords, just need to prep them to hand over to new company to use.
Just want to verify how do I factory reset them from GUI and Command line to see f there are any gotcha's?
Best,
Rick
Sorry to keep bothering you.
So after I run those commands and delete VLAN dat, I reboot and the three switches all come up in a stack configuration and factor reset?
Cisco mentioned I had to break the stack and run commands individually, your way i...
Thanks, should I also delete LAN info?
delete flash:vlan.dat
When this is complete, will the switches all come up in default mode in a stack configuration? they will be re-used with a new config.
Thanks
