Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, WLC 5508s running 8.0.121.0 Have had success using the Airespace-wireless-MIB for graphing client protocol information bsnMobileStationProtocol ='1.3.6.1.4.1.14179.2.1.4.1.25' ; # Protocol, 1=a, 2=b, 3=g, 4=unknown, 5=mobile, 6= dot11n24, 7=d...
Hi,Have an ipsec tunnel working for a branch campus without problems for over a year. Clients come back direct to main campus, if destination is off campus, then go direct out to Internet without coming back the ipsec tunnel. Configuration is attache...
Greetings, Need to setup a temp (30 days) until new circuit is installed GRE tunnel passing 802.1q tagged vlans. Tried following vlan routing and bridging on a router using the irb from: http://www.cisco.com/application/pdf/paws/17054/741_10.pdf but...
Hi, Test setup for AP 1142 and 5.2.178.0, have a 2106 running 5.2.178.0 with 1142 with two WLANs. Working OK but for VPN connections. See PPTP control messages between wireless client and VPN server up to the (Set-Link-Info), nothing after this from ...
HI,> I changed it to 86400 during the day. You think I should VPN at night and change it, and change it back?No, leave it at 86400. My attempt at a joke about the comment in the open Caveat Workaround: " • Executes the config advanced eap bcast-key-...
Little late but fyi, Open Caveats on 7.4.100.0, CSCuc78713 could be related to this;CSCuc78713Symptom: Wireless client cannot receive broadcast packets after broadcast key rotation.Conditions: Dynamic WEP; 7.0.235.0, 7.2.110.0, and 7.3.101.0 controll...
Hi Torleif,Did you ever have any luck getting rid of these messages? I just upgraded a WS-C2960S to version 15.0(2)SE and have started logging the same messages. Searching and only found what you show above, "No action is required" but I would like t...
Hi,Not pretty but I got this working.Created GRE tunnel and a route-map with "set ip default next-hop" pointing to the new tunnels remote address. Web traffic now stays internal.thanks!
