Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!I have a problem with RSPAN. I have 2 CAT6500. I need to monitor ports on both 6500. The destinations are in both 6500 too. I configure the following monitor session on both 65000.monitor session 1 source interface Gi6/28 - 31 , Gi6/34 - 35 , Gi6/...
Hello !!Can i install CM Bundle (with sybase) for solaris in a SUN with x86 (no SPARC). When i to istall it i recieved the following error:Sun Microsystems Inc. SunOS 5.10 Generic January 2005-bash: /usr/tmp/sybinstall595/setup: Invalid argume...
When i try to modify the quota assigned to a subscriber i recieve the following error:[pcube@scmscm ~]$ sm/server/bin/p3qm --set-quota --subscriber=ccomelli --bucket=1=3000000Error - Failed to set quota ...No quota information exists for subscriber c...
Hi!I configured a VLAN in a 6500 for multicast traffic. There are sources and clients. I enabled IGMP SNOOPING and Multicast Routing. I enabled PIM in the interface VLAN too. I see that the SW is flooding the multicast traffic in all ports in the VLA...
Hi!I configured 1 VRF in a 7600. I need to send some packets from the global table to that VRF. I configured 2 ports, one in the global table and the other in the VRF and join the 2 ports with a crossover cable. To send the traffic to the VRF i used ...
Ok. last question: In my case, If you enable MULTICAT-ROUTING and IGMP SNOOPING, Could the SW send the multicast traffic to the correct port? without flood the traffic. I think the SW has the data in order to do thatThanks a lot for your HELP !!!!!!
we have one source y a few client in one VLAN. In the same vlan there are some PC. These PCs are recieving the multicast traffic. There is no multicast clients outside that VLAN. if I configured IP IGMP SNOOPING QUERIER, the SW sent multicast traffic...
No. The neighbor router doesnt run PIM. I see that the problem is when the SW is the IGMP Querier (I test with 3560 and 6500). When the SW is the DR (or querier) in a VLAN, it flood the multicast traffic in all port for that VLAN. I tested this with ...
I used the IP 239.0.0.1 and 239.1.1.1 with the same results. I did the show ip igmp groups and saw the last client (the only one) int the GE8/2, but the SW was flooding the multicast traffic to the GE8/4 too. (All in VLAN 1). Behind GE8/4 there was a...
