Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have CM 6.0 running in a lab and we have a SIP provider. I was curious is it possible to configure CM and configure it to use the SIP provider? We have tried but cant seem to get it to work. Xlite works fine so I know the firewall is not blocki...
I can not get IP communicator to work for nothing. The status keeps saying TFTP Timeout 7A.cnf.xml and CTL update failed. I have tftp service running as well as other services.Finally, my other question is when I click on Cisco Unified Serviceabili...
I have a customer who had a frame relay circuit that we were doing frame relay traffic shaping on. The voice quality between the two sites worked fine. They currently switched to a frame-relay mpls system offered by Bellsouth.The voice quality is v...
I have a point to point T1 between two cisco 2800 routers. Bellsouth admitted the circuit had breaks in it. They tested the line for 8 hours and traced the circuit back and repaired the line. But I still get line protocol as being down. I configu...
5km radius is around 3 miles. Im not sure a 8 dbi antenna can push it that far. Are you trying to cover a large radius or just a confined area? If your not covering a radius get a Yagi antenna and shoot the beam in the direction you want the signa...
Does it have to be a router with firewall feature set? I would do a router and a firewall. I'm not a big fan on relying on a router to do firewall stuff for 80 users in this cas.e
When you change the config register to 0x2102 and reboot it everything loads properly. Once it boots back up normally and loads the config file you need to once again change the config register to 0x2102 and write it to memory. Just because you cha...
