Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
As they say " its possible to use same ip address for loopback interfaces in different VRFs"but even if ospf process running in different VRF they cannot use same router-idbut my question is "why this kind of behaviour?"is this ospf which is not allo...
Scenario :R1--IBGP--R2--EBGP--R3 R3 with private AS If we use this command "remove-private-as" at R2 to remove private AS while it advertise R3 prefixes to its neighbors.I think if there is IBGP between R2 and R1 then R2 wonnt strip the private AS fr...
Scenario :-R1--IBGP--R2--EBGP--R3R2 applies community AS:NN to inbound updates of R3 route-map test permit 10 set weight 0 set origin igp set community AS:NNthen while sending the updates to R1 and applies the following route maproute-map set-next-ho...
In OSPF Hello process, if any of below mentioned item does not match, two routers do not form neighbor relationship:-- Must Pass Authentication- Must be in the same primary subnet, including subnet mask- Must be in same OSPF Area- Must be of same are...
Hi Scott,try NAT overload with route-map rather than aclI think it should work, But WHY?? I vaguely remeber but not sure, will try to dig out something for you.e.g.ip access-list standard INTERNET_ACCESSpermit 10.2.1.0 0.0.0.127route-map test permit ...
Hi,When operating at full-duplex, FCS, cyclic redundancy checks (CRC), alignment errors, and runt counters should be minimal. If the link is operating at full-duplex, the collision
counter is not active. If the FCS, CRC, alignment, or runt counters a...
Hi Taran,when you say Firewall does not support VIP, it is fine. Can you plese tell me how HA works in your firewall .what are IP addresses configured on your firewall and what will happen when primary fails ? and what is router's next hop IP Address...
Hi,Agree with Calin that shaping is concept which is independent of vendor. Only configuration & specific features may change.But products like packeteer give many more features like compression and also they have much better monitoring & reporting f...
Hi Manie,STP path cost used to be linear and calculation was very simple , 1000/Bandwidth in MbpsAs 1 Gbps & 10 Gbps came into picture, path costs have been revised and formula is not availavble (atleast I could not find it). cost are non-linear now....
