Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there, I have a strange issue in terms that I can install successfully the certificate on the vManage, vBond, but not on vSmart.When I try to install the cert on vSmart I get complains about "Error: root-ca-chain unable to validate the certificate...
Hi,
I have the following problem and I've reached a point where I don't know what to do anymore.
Scenario:
2 x Cisco 4500-X in VSS mode.
2 x VSL Ports - 10G with SFP+ (Proline SFP-10G-SR-PRO)
1 x Dual-active fast-hello Port - 1G with SFP (Proline G...
Hello,How long does it take for your APIC-EM installation to start all the Services? I have a fresh installation, all HW specs are meeting the requirements, single node and after about 40 minutes there are still some Services which are not started. I...
Hello all,
I read all possible documentation, try it, but I would like a confirmation on the following.
There is no way I can connect a N2248PQ with FET-10G on the N2K side, right?
From my knowledge the N2248PQ supports only FET-40G on the 4 x 40G po...
The image is small, but if I see correctly you selected "Fabric 1 only".If you manage both fabrics through ND, then select "Both Fabric 1 and Fabric 2" option.If you manage only one of the fabric through ND, then you need to manually create the VRF o...
I’ve created a VM in Proxmox to match the required HW specs for ND and then installed from iso image. These are the VM settings: Was the most straightforward way to do it (at least for me). I’ve documented the full process in an article (will send y...
I found a solution, but is definitely for testing ND with Proxmox. I wouldn't recommend it for production use and expect Cisco to provide some official guidance for ND and Proxmox.Anyway, here is what I did in short:1) Boot the ND VM (which is Debian...
