Dear Expert, I have 4 VRF (vrf01, vrf02, vrf03 and vrf04) and each VRF have 4 VLANs. 2 VRF's networks (vrf01 and vrf02) are most important and want to configure QoS on Cisco N9K switches. would you please advise me the procedure and CLI command for c...

Dear Experts,I have a confusion to configure BGP in my network. I have 2 nexus switches and they will be connected with MPLS router. There will be vPC between 2 nexus switches and eBGP will be configured between nexus switches and MPLS routers. No ot...

Hi Experts, This is first time I am deploying the cisco hyperflex and facing many issues. Can any one provide me the step by step configuration procedure?   Please find the attachments.   Thanks...

Dear Expert, I am deploying a cisco firepower and don't want to use mgt port. I want to use outside interface ip address to the sfr module. Is is possible?? Please suggest.   Thanks....

Hi Experts, I am replacing a 2960 switch with N3K‑C3524P‑10GX. But the switch port is not responding when i connect the server. There was no configuration in 2960 switch. and I configured the below in nexus switch: [1 GLC-T is connected on Eth1/1 and...