Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have cisco 3560X-24T-s with IP Base licence that need to route multicast packets between vlans and also other similar switches.
I wanted to know if I can preform the "ip pim dense-mode" command on its interfaces (interface vlan/interface gi...
Hello,I configured SPAN (monitor session) on my 3560 switch and it works fine until the destination port disconnect from any reason (shut no shut, cable unplug, restart destination computer). than the destination port don't show any traffic from the ...
Hello,I have switch Catalyst 3750G-24TS-1U with IOS Release 12.2(35)SEWhen I try to write the command "ip multicast-routing distributed" it not recognize it.When I checked it on the internet it didn't show me any problems to use it. Please helpThank...
Hello,I have Aironet Air-AP1041N and I wrote it the next CLI commands to define its wireless:interface Dot11Radio0 no ip address no ip route-cache no shutdown ssid mPrest_Test speed basic-1.0 basic-2.0 basic-5.5 basic-11.0 station-role root access-p...
Thanks a lot Mark.
What it's mean "pim stub routing" and what is the different from "complete multicast routing"?
And also, in my IP Base license I can put the command "ip pim dense-mode" on interface gigabitethernetx/x. What the difference from int...
Hi,I upgrade my 3750G to os 15.02SE8 and now I can write this command but I can't define multicast routing in the interface vlan. I checked little more and i found that: "Catalyst 3750 and 3560 switches run feature-specific software releases and do n...
Thanks, Now its work but how can I make the radio to work with the gigaethernet interface that everyone that connect to the SSID will connect the gigaethernet interface?
