Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
if there are two equal cost ISIS routes, then there will be two LSP's for a FEC. but in MPLS only one FEC should be used.on what basis will this selection be made?can we balance load across links in a port channel in MPLS, how?also in VPLS scenario w...
hi,I have a service instance with an encapsulation of vlan 100, I hav also defined a VFI called hhh and later defined service instance 2 ethernet description IDP encapsulation dot1q 100 interface vlan 100xconnect hhhno ip address will this bind vf...
hi in my network, I have a switch (D) connected to multiple switches(A1,A2,...) and the VLAN's repeat in each of these switches (A1,A2,..). I want to use MPLS layer2 VPN concept here. please tell me should I go with VLL or VPLS and why?also if possib...
hi I have the following configuration:interface Port-channel1 description SHN-AX1-1-2-CNRY switchport trunk allowed vlan none switchport mode trunk load-interval 30 no keepalive service instance 1 ethernet encapsulation untagged l2protocol peer lac...
hi Anand,it would be really helpful if you tell me the tables and ID's to look into when tracing the end to end traffic by capturing packets. thank you.
ok. I have configured service instances on EtherChannel group.So you mean to say that after creating a service instance on a EtherChannel, the switchport mode trunk command is not allowed on the interface.
hi,so in that case the following configuration is incorrect:interface GigabitEthernet0/1 switchport trunk allowed vlan none switchport mode trunk channel-group 1 mode on the customer facing interfaces should not be in trunk mode, right??
