Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyonei think over to add on my C2951 a ucs-e140m1 card from Ebay, the price are realy in the mean time run down.interssing my are to deploy on this ESXI, so that are possible to run Eve-NG, or GNS3. this intention are only to build out my la...
Helloon me setup i have two company "A" with Cisco rv042g and company "B" Zyxel USG 220.this two are connected over tunnel (internet) with IPsec 3des and (1024bit group) configured,and this running... but! I have now missured the transfer speed that ...
Hello Play with entenssion to buy used Cisco 1941 after searching i see meny K9 with Permanent Security. Please what would now mean "Permanent Sec" feature, this will running in x Day for triala mode "Permanent" or i Need to buy direct a 1941 K9 SEC ...
Hello
i'am Beginner and not shure if understanding the "Deny" correct.
Please i Setup now my Router and i was thinking that if pushing this Setup
my prefered ports are now "closed".
"ip access-list extended blocks-2002-4002-ports deny tcp any a...
I have also try to add following, but this will not appair....please, but with witch command i can check what are running or not?
conf tclass-map type inspect match-any www match access-group 100class-map type inspect match-any RDP match access-group...
