Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I am going to be installing a few 9300 switches at my location and I am looking for a guide or information about activating the inbuilt WLC on this platform.
Does anyone have any guides or information on how to activate this feature set? ...
We are experiencing an odd issue with one of our Catalyst 4500X switches.
We recently installed a new one of these into one of our campuses as a replacement for the Core switch of the site. We had already installed one into the Core of another site...
Hi All,
At my workplace, we have a setup which contains Cisco 5508 WLC's currently running 7.6, mainly to enable us to use the 3702 access points. These work fine with our Prime Infrastructure device, which is running version 2.2.3. There is no upgr...
Not the best situation there. Is there a later version of the image you could use? If you can reliably reproduce the error you could test with a downgraded version maybe. Your situation seems slightly different to what we were experiencing from your ...
I did end up downgrading and the issue has not reoccured at all. I hopeyour results match mine. At least it wasn't mass amounts of downtime, onlya restart of the switch after changing the boot image.
I understand there is no official support and have gone through these documents. What I would like to know is if the devices can connect at all to each other.
So can the Prime 2.2.3 connect and pull information from the WLC at Version 8.3 at all?
W...
