Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
dearI m receiving the following error%SNMP-3-INPUT_QFULL_ERR: Packet dropped due to inputqueue full%SNMP-3-INPUT_QFULL_ERR: Packet dropped due to inputqueue full%SNMP-3-INPUT_QFULL_ERR: Packet dropped due to inputqueue full%SNMP-3-INPUT_QFULL_ERR: Pa...
Dear I have core switch with vlan 1 configured , and access switch that is connected to core switch . core config int vl1 1ip add 10.31.1.1 255.255.255.0 int loop 100ip add 10.70.1.1 255.255.255.255 sho ip route 10.70.1.1Core1#sho ip route 10.70.1.0...
Dear I have 2 core 4500 with the below config :Core 1interface Vlan202 description VLAN FOR VOICE ip address x.x.x.2 255.255.248.0 no ip redirects ip pim dense-mode standby 202 ip x.x.x.1 standby 202 priority 90 standby 202 preemptend core 2interfac...
HIi have access point with tow SSID one for staff and the other for students,i m doing MAC authentecation . lets say that staff is accessing vlan 10 and student going for vlan 20.i have tow groups on the ACS group1 with staff MAC address , Group 2 wi...
hias i know that if i have a "b" clientsin my network connected to my AP, they will definitely lower the connection of all my wireless clients.so all "G" clint will connect at the speed of 11 mbwhat about "N" "G" if i have a N AP with mix clint of N ...
so your issue is that you are not able to ssh or telnet switches on site b from your PC ? is that correct if yes then :are you able to ping 10.103.243.254 or 10.103.243.254 from your PC ??if no then its isp issueif yes then we have to troubleshoot mo...
yesss and that's why I m confused CAB1-sw1#ping 10.70.1.1Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.70.1.1, timeout is 2 seconds:!!!!!Success rate is 100 percent (5/5), round-trip min/avg/max = 1/3/8 msCAB1-sw1# this means icm...
thank you jon for your replyI will quote"The access switch then sends it's ping packet to the core switch with the destination mac address of the core switch vlan interface."this is the echo request . it reaches the core switch and then the loopback ...
