Hi to everyone.
I´m stuck with my WLC 5760, I activate the evaluation license for 1000 AP, and after I join 26 AP´s the 27th does not join. I check with others AP and presents the same situation, not joining.
The AP have previously downloaded the f...
Hi all!!I recently configure my MCU 4501 in order to manage the VC service on our central offices. I see my endpoints registered, but, in the moment that the MCU calls to the endpoint, appear the following message:28311:34:06.011 CONFERENCEWarninguna...
Hi everybody!! I recently upgraded my CUCM to version 8.6.2.21900-5, and my EX60 to TC 5.1.2. When I try to register directly the EX60 on my CUCM, appears to be UNKNOW status, but later, the EX60 starts a new "System Upgrade", and after a few sec...
Hi everyone...I have a CCM with Version 6.0.1.2000-3 and platform 7825I3.Recently (1 week) I have unregistered phones, I check the network (0 problems) and I found a memory problem. My server has 2 gb and I have actually 1.99 Gb of use. In the list o...
Hi all!!
I made a clean install on the WLC, and everything its working pretty good right now. I don´t know how to classify the issue.
Thanks for your support.
Thx Sandeep!!
There you go....
IOS Bootloader - Starting system.flash is writableTide XL MB - 40MB of flashXmodem file system is available.flashfs[0]: 60 files, 8 directoriesflashfs[0]: 0 orphaned files, 0 orphaned directoriesflashfs[0]: Total bytes...
Hola Amlesh!!I tried your guide and I have the same error, the EX60 doesn´t register on the CUCM, I follow every step of your setup and did not work.Tomorrow I will continue trying, and post my results.Thanks again for your support and guidance.Best ...
Hello Mubashshir!!I download the file from the Cisco repository, and correctly installed on my CUCM, also installed the newest device pack.In the Device-->Device Settings-->Device Defaults menu, in the EX60 line, appears the load information (s52000t...
