Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In reference to setting up a Certificate Authentication Profile ...
I see that "basic certificate checking" does not require an identity source. I'm wanting to ensure I know what "basic certificate checking" means. My assumption is the all that is ...
I have a number of 3750X and 3850 switches that I need to upgrade. I've been surprised in the past with microcode updates that take place at the reboot of the switch. When working without console access it is a bit alarming when the switch doesn't...
I am looking at channel usage on 3 different controllers and see on all three that the UNII-1, 2 and 3 channels are available for DCA to assign (not the UNII-2 Extended). When I look at the APs on those controllers I see maybe a half dozen out of 50...
I'm trying to find the port groups for VDC assignments for the N77-F324FQ-25 module. The data sheet doesn't seem to have it, can't seem to find that information anywhere. The best advise I could find was the show hardware internal dev-port-map - I ...
I have read the release notes and user guide for ACS 5.4 that mentions the capability to join the ACS nodes from same deployment to different AD domains. But each node can be joined to a single AD domain. My question is this ... in a failover situa...
Your config has the desired effect. To bad they don't give you access to a command line on the PC to test (which you should always do if at all possible). I rebuilt the lab using your config and PCs that could ping and everything was as desired. ...
Perhaps a minor exaggeration but anywhere from 15 to 25 is not at all uncommon. In some of those cases I was on the console watching it so I knew it was the microcode. Hard to believe that there is no way to anticipate this but if that is the case ...
The mesh is set to in-out. Looking at the Mesh Design & Deployment Guide:In-out mode—The RAP and MAP both multicast but in a different manner: –In-out mode is the default mode. –If multicast packets are received at a MAP over Ethernet, they are...
No VLANs. The L3 interfaces and the Mesh APs are all in the same subnet/VLAN. The interfaces on the switches where the APs are connected are just access ports.
