Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,
I am facing a weird issue, following are the details
I have ISE version 2.3 Patch 3 with Anyconnect 4.5.530 with 4.3.215 Compliance ModuleMajority of users posture is working fine and in ISE logs it shows compliant Some users posture s...
Hello All,
My posturing is working fine but i tried to enable Split tunnel from ASA it is not coming into effect
I asked Cisco TAC if we can push split tunnel ACL from ISE but as per Engineer it is not supported
My issue is i am getting 0.0.0.0/0...
Hi All,I need to know from which link can i get versions of BIOS , CIMC , Host firmware packages versions ... I am making LLD so i need to include this informationAnother question i have is that .. I have M81KR with B230 M2 cisco compatibility matr...
Dear Cisco Rep,I am in need of Cisco Fabric Interconnect Blank Module Stencil but i am not able to find it .... Kindly provide mePart # UCS-BLKE-6200 UCS 6200 Series Expansion Module BlankThanks
Hi all,Please let me know if i implement IKE V2 on Cisco ASR 1006 Router or on firewall and sets up IPsec with IKEv1 device ( Cisco Router , Juniper etc )will it work or not ? If yes , please share document to review it further
Hi Serhii,
I discovered one more issue
1. I have 7 PC(s) and they are connected to LAN and its posture showing Not Applicable in ISE , the moment i disconnect them from LAN and they switch to Wifi , it start showing Compliant in ISE
2. Vice versa...
Hi,
@tommy182 @howon
I dont have Device Sensor enabled on switches
Also i discovered the same issue that posture happening on another PSN and authentication on another.
Its difficult to upgrade to 2.4 and rollout 250 + users to 4.6
This is the ca...
