Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Two Meraki MS320 switches both on different IP addresses, could i use a TWINAX cable to have a 10gig link between the switches, which are about 3 meters apart (if that)
Hello Community
I have successfully been able to connect to my network configuring the ASA to allow Cisco Anyconnect client.
Once connected, i am not able to browse the internet but i am able to ssh/http onto my servers. I suspect i have not c...
Hi,
Ok, so i have completed wiped the config of the ASA 5506, I still cannot get access to the ASDM via the inside interface.
When i enable the BVI 1 interface, manually assign an IP address and set gig 1/2 as bridge group 1 this works .
Is there a...
System Name Cisco Master AP Model AIR-AP1832I-E-K9Software Version 8.3.112.0Management IP Address 192.168.108.99
Guys,I am trying to set this Primary AP up, below is my scenario:
Local users currently have a LAN address of 1...
Thank you for this.I have configured this as below:interface GigabitEthernet1/2no nameifno security-levelno ip addressinterface GigabitEthernet1/2.1vlan 1nameif INSIDEsecurity-level 100ip address 192.168.15.1 255.255.255.0!interface GigabitEthernet1/...
https://192.168.108.99 - Management Interface via a Cisco ASA
Local IP address 192.168.108.89
Gateway 192.168.108.1
I want to use the local DHCP server for GUEST wifi ( this AP is able to act as a DHCP Server)
IP address 192.168.33.0
Configured f...
