Hello everybody.I am starting to install a couple of C9300 in a campus of my company. The two switches will be installed in two separate datacenters. Every C9500 switch will be connected to every other building of the campus. In this way, every build...
Hi everybody.I have a new C9500-48Y4C with firmware version 17.12.04: this is the last recommended version by cisco. I have a problem with configuring port-channel on the switch. I show the commands and the outputs.C9500.(config)#int port-channel ?<1...
Hello to everybody. I need to monitor the status of several C9300 health in general. I mean that I want to know if the system led is green, amber or red via snmp variable: is there a such variable?best regardse.frediani - italy
Hello everybody, when I type "show lldp neighbors" on my 2960, I have an output like this: POLI-61A-192.168.100Gi1/0/25 120 B Gi1/0/25The first column represent the remote device ID, but it is cut to the first 20 chars only...
Hello everybody
in my company we have a Cisco WLC 5508 that controls about 20
AIR-LAP1261N-E-K9 accesspoints. Now we need to enlarge our wifi covered area but the specified accesspoint model is end-of-life. Can someone specify an equivalent accesspoi...
FYI: I erased the whole configuration and reconfigured the stack (with 17.12.04) with the original configuration: all the commands have been accepted. thank you to everybody
I have good news and bad news.The good news: I re-upgraded the stack and now the channel-group 1 command works correctly.The bad news: now the vlan commands do not work. I tried to create a vlan and assign it to a trunk port:C9500#sh run | be 2/0/1in...
Thank you to your answer. I detail more the switch configuration and add some other things. I read the useful guide suggested by marce1000 and found that I already made the right things. I show you the port configuration:interface TwentyFiveGigE1/0/4...
I try to explain further my need. I would like to check if the system reports an error like a fan removed. I see that if I unplug a fan from the C9300, the system led becomes amber, but I do not find an snmp variable that makes evident this anomaly. ...
