Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, we using in our company devices with multiple ethernet devices in 1 box. We want to bring the single ethernet devices in the box in different VLANs.The problem is that the devices in the box are embeeded on 1 PCB with the switch and we have only ...
Hi All,
we have the following hardware setup:
4x SG350X-48 (Access)
1x SG350XG-24F (Core)
All of the 48 port switches have a 40Gig LAG with 4x 10Gig SFPs to Core switch. So the Core switch have 4x 40Gig LAGs with 4x 10Gig SFPs per LAG to the Access...
Hi all,
I have a problem with the following setup. We have multiple offices connected via VPN to the HQ, because two offices sharing a lot of data, we want add to the ASA 5505 firewalls a second VPN site-to-site tunnel to transport the traffic direc...
Hello,we have a Internet connection with static IP addresses, to get the IP, you enter the MAC address of the interface on the website of the provider and you get via DHCP your static IP address. We are using a ASA 5505 as firewall between the intern...
Hello, we have the following setup. The CUCM connect via SIP trunk to a Cisco 2921. The 2921 have a SIP trunk to a phone provider and BRI interfaces for ISDN connections. The SIP trunk provide the phone numbers for office 1, the BRI interfaces the ph...
We have Cisco 9300 switches.Do you have a configuration example for me, currently with MAB a port is only in 1 VLAN, but I need it that the port is like a trunk port and over the source MAC address the switch will put the single packages in the VLANs...
Hi,
please correct me if I'm wrong, but with this configuration, if I wanna connect to the site B from site A, I use a IP from the IP range 192.168.20.0/24? In this case, the DNS servers give me the wrong IP addresses for the hostnames or I must conf...
Hi,thanksI tried the second option, how can I configure the dial-peer with a prefix of the source of the call?I found in the documentation only the destination-pattern command for a outbound dial-peer. RegardsAndreas