Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all!!,
I have 8 ISE nodes (2 PAN, 2 MNT and 4 PSN) old model nodes SNS-3595-K9 and I want to replace them for new models SNS-3755-K9...
1º I've shutdown one of the old PSN nodes
2º Disconnect the old node from network
3º I deregistered old psn nod...
Hi everyone!!Today, all my Meraki APs of one of my offices in Brazil went DOWN in Meraki Dashboard... all services in the office worked correctly for all services, except connection to Meraki Cloud... I could ping to my Access Points internally, so t...
Hi guys!! is possible to allo webex audio calls between clients connected to the same SSID, with "Layer 2 LAN isolation" enabled?Thanks for all!!Marcos
Hi everyone!!
My Cisco ISE 2.7 patch 9 deployment Operational backup doesn't work since some weeks ago (weekly scheduled backup). We have the same repository for different backups (Operational, Configuration, Policies... and other reports...) and onl...
Hi guys!! I have an error in my DNAC installation, after switch to 2.x version... all devices WS-c2960s... are detected as 2960-X/XR series, so the Software Images menu show all switches of this models in OUTDATED state... because the IOS for 2960X ...
It helped me. thanks!!
Before:
switch#show file systems
File Systems:
Size(b) Free(b) Type Flags Prefixes* 1956839424 845561856 disk rw flash: bootflash: flash-1:1957167104 1352138752 disk rw flash-2: stby-flash:
Solution:
switch#conf t
Enter configu...
Thanks for your reply, I opened a ticket with TAC and I'm waiting for them, my post was for check if it's a general error with a simple solution without wait for TAC support. Thanks for your replies
If you check my point 4º when I install the version in new HW (ISE version 3.1) ... and 5º when I install patch 9 in new HW... then, my current version in old current production environment is 3.1 patch 9
Thanks
If you check my point 4º when I install the version in new HW (ISE version 3.1) ... and 5º when I install patch 9 in new HW... then, my current version in old current production environment is 3.1 patch 9. I saw the bug before I wrote here, but that ...
