Hi
I'm looking for a Switch or Router with minimum 3 SFP port + 3 RJ-45 GE port and VRRP, HSRP, OSPF V3, RIP V3, BGP support
It will be used in a branch.
Which equipment Should I consider?
Thank you?
Hi, This is my scenario,7200 (PA-MC-T3) T1 #28 <---(DS3)---> MX2820 <--(DS1)---> CISCO2651XM (WIC-1DSU-T1),the link works fine, I have serial up and protocol up over 7200 and the 2651XM T1 serial interfaces, OK !!!But, if i used a VWIC-1MFT-T1 c...
Hi Could you help me with next issue?I have 2 routers 7206 VXR (NPE-G2) with PA-MC-8TE1+ cards (both)a L2tpV3 pseudowire was configure between the routers using the T1's.all my application works but when i try to check the T1 pseudowire link with a...
Hi, Im Using PPTP for Remote Access to my VPN server, its able to connect to remote LAN but I dont have Internet access from remote side, Is that i need..Im using windows PPTP client, and it has select the "Use default gateway on remote network" opti...
Hi , I used HDLC without success,this is the show information:CISCO2651XM with VWIC-1MFT-T1T1MFT-TEST-EZERO#sh controllers T1 0/1T1 0/1 is up. Applique type is Channelized T1 Cablelength is long gain36 0db No alarms detected. alarm-trigger is not...
this is the pointhow can I configure the firewall to re-route traffic to Internet while I connected to VPN.The Internet used must be from the side where is the PIX, because I need centralize the service.At the first post is current configurationCould...
Federico, Thank you for your response.this is the exit from CLI while I'm connected to the VPN, I received Ip Address form the VPN poolEthernet adapter Wireless Network Connection: Connection-specific DNS Suffix . : xcnetworks.com IP A...
