Hi , I used HDLC without success,
this is the show information:
CISCO2651XM with VWIC-1MFT-T1
T1MFT-TEST-EZERO#sh controllers T1 0/1
T1 0/1 is up.
Applique type is Channelized T1
Cablelength is long gain36 0db
No alarms detected.
alarm-trigger is not set
Soaking time: 3, Clearance time: 10
AIS State:Clear LOS State:Clear LOF State:Clear
Version info Firmware: 20090113, FPGA: 20, spm_count = 0
Framing is ESF, Line Code is B8ZS, Clock Source is Line.
CRC Threshold is 320. Reported from firmware is 320.
Data in current interval (100 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail
T1MFT-TEST-EZERO#
T1MFT-TEST-EZERO#sh int serial 0/1:0
Serial0/1:0 is up, line protocol is down
Hardware is PowerQUICC Serial
Internet address is 10.10.200.2/30
MTU 1500 bytes, BW 1344 Kbit/sec, DLY 20000 usec,
reliability 200/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP REQsent, loopback not set
Keepalive set (10 sec)
Last input 11:29:54, output 00:00:00, output hang never
Last clearing of "show interface" counters 00:02:10
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops:
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1008 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 12 giants, 0 throttles
18 input errors, 1 CRC, 8 frame, 0 overrun, 0 ignored, 9 abort
27 packets output, 378 bytes, 0 underruns
0 output errors, 0 collisions, 6 interface resets
0 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Timeslot(s) Used:1-24, SCC: 1, Transmitter delay is 0 flags
T1MFT-TEST-EZERO#
***********************************************************************************
7200 ROUTER
ATT-COLO-7206#sh controllers T3 2/0
T3 2/0 is up. Hardware is CT3 single wide port adapter
CT3 H/W Version : 1.0.1, CT3 ROM Version : 1.1, CT3 F/W Version : 2.4.3
FREEDM version: 1, reset 0 resurrect 0
Applique type is Channelized T3
No alarms detected.
Framing is M23, Line Code is B3ZS, Clock Source is Internal
Rx-error throttling on T1's DISABLED
Rx throttle total 0, equipment customer loopback
Data in current interval (17 seconds elapsed):
13 Line Code Violations, 8 P-bit Coding Violation
0 C-bit Coding Violation, 0 P-bit Err Secs
0 P-bit Severely Err Secs, 0 Severely Err Framing Secs
0 Unavailable Secs, 0 Line Errored Secs
0 C-bit Errored Secs, 0 C-bit Severely Errored Secs
T1 28 is up
timeslots: 1-24
FDL per AT&T 54016 spec.
No alarms detected.
Framing is ESF, Clock Source is Internal
Data in current interval (48 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs
0 Unavail Secs, 0 Stuffed Secs
0 Near-end path failures, 0 Far-end path failures, 0 SEF/AIS Secs
ATT-COLO-7206#sh int serial 2/0/28:2
Serial2/0/28:2 is up, line protocol is down
Hardware is PA-MC-T3
Internet address is 10.10.200.1/30
MTU 1500 bytes, BW 1536 Kbit/sec, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation PPP, LCP REQsent, crc 16, loopback not set
Keepalive set (10 sec)
Last input 2d17h, output 2d19h, output hang never
Last clearing of "show interface" counters 00:01:29
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: weighted fair
Output queue: 0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/1/16 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
Available Bandwidth 1152 kilobits/sec
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
29 input errors, 0 CRC, 12 frame, 0 overrun, 0 ignored, 17 abort
40 packets output, 560 bytes, 0 underruns
0 output errors, 0 collisions, 4 interface resets
0 unknown protocol drops
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions no alarm present
Timeslot(s) Used: 1-24, subrate: 1536Kb/s, transmit delay is 0 flags
non-inverted data
ATT-COLO-7206#
Thank you
