Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears, I know it may look a very bacis question, but frankly I searched the net, books & asked many friends and no one could help.I want to create one or two access list to hit the following ip prefix.192.168.2.0192.168.6.0192.168.11.0192.168.15.019...
Dear, I'm planning to deploy an AAA in my network, And want your help.-Because I have a multi-vendor network components, should I use tacacs or radius??-And, windows has radius but not tacacs?? So from wher I can downlaod the tacacs servie & server.-...
Dear, I always assigned the task for evaluating a network products, like cisco,3com,nortel, hp and etc.And want to know what tools should I use to compare them like , speed, performance, etc, in a lab that I can set.Is there any specific software you...
Dears, Please, I want to understand this issue,In the case that we have a Multi-Vlan networks, L2,L3 switches, and DHCP.I know how to configure this and enable the ip connectivity for the user, but I'm asking about how would the DHCP assign the corr...
Dear All, I want to ask about the following: -Baseline network model??? what is it , and how to read more about it from the Cisco point view??? -MTTR & MTBF??? and how it is relate to the baseline network model ( increasing or decreasing)??
Dear Rick, Thnak you very very much for the fast response and also for the datailed explanation. I tried it with other combination and it works well.regards.Moe
Dears, What is the configuration needed to enable the Lucent (Definity) PBX to connect to cisco 3825 router- using E1 controller-.I mean what is the E1 channels, singlaling etc...
