We are looking to install a new NPE-G2 processor card into an existing 7204VXR chassis to replace our current NPE-400.While researching a suitable IOS release, the software advisor has highlighted that even though the NPE-G2 ships with 1GB of RAM, th...

We have installed redundant PRP-2 modules in a 12010 chassis and we were under the impression that the Ethernet ports (eth0, eth1 and eth2) could be used for routing purposes.I have found documentation on the older PRP modules which states - " The PR...

I've been asked to implement a 1Mb ethernet service with a 10MB burst.As QoS is not my strong point I'm looking for advice on whether the following configuration is correct: rate-limit input 1000000 10000000 10000000 conform-action transmit exceed-ac...

I've been asked to research VPLS and the feasibility of deploying it across our core.I understand most of the underlying concepts but I just need one point clarifying for everything to fall into place.When it is considered that all sites in the Layer...